Search results for "Stress field"

Development of branching brittle and ductile shear zones: A numerical study

2017

Continental collision zones are usually associated with large-scale strike-slip shear zones. In most cases these shear zones are complex and consist of multiple strands, varying in width, length, and total displacement. Here we present 2-D numerical models to simulate the formation of such shear zones at different depth levels within the crust, under either brittle (frictional/plastic) or ductile conditions. Localization of shear zones is initiated by a material contrast (heterogeneity) of the material parameters. We systematically test the rate of strain-weakening in brittle and in ductile regimes to understand its influence on the development of shear zone networks. Our simulations sugges…

Complex geometry and kinematics of subsidiary faults within a carbonate-hosted relay ramp

2019

Abstract Minor fault geometry and kinematics within relay ramps is strongly related to the stress field perturbations that can be produced when two major fault segments overlap and interact. Here we integrate classical fieldwork and interpretation of a virtual outcrop to investigate the geometry and kinematics of subsidiary faults within a relay ramp along the Tre Monti normal fault in the Central Apennines. Although the Tre Monti fault strikes parallel to the regional extension (NE-SW) it shows predominant dip-slip kinematics, suggesting a NW-SE oriented extension acting at sub-regional scale (1–10 km). Conversely, the slickenlines collected on the front segment of the relay ramp highlight…

2018

Abstract. The orientation and tectonic regime of the observed crustal/lithospheric stress field contribute to our knowledge of different deformation processes occurring within the Earth's crust and lithosphere. In this study, we analyze the influence of the thermal and density structure of the upper mantle on the lithospheric stress field and topography. We use a 3-D lithosphere–asthenosphere numerical model with power-law rheology, coupled to a spectral mantle flow code at 300 km depth. Our results are validated against the World Stress Map 2016 (WSM2016) and the observation-based residual topography. We derive the upper mantle thermal structure from either a heat flow model combined with …

ON THE EFFECTS OF A CRACK PROPAGATING TOWARD THE INTERFACE OF A BIMATERIAL SYSTEM

2006

This paper deals with the influence of matrix cracks on the failure mode of bimaterial systems and composite materials. In order to investigate such an influence, the stress field near a crack embedded into the more yielding material and propagating perpendicularly to the interface, has been analyzed by using systematic numerical simulations. Such analysis has shown that the crack propagation give rises to transversal stresses that can damage the reinforcing materials when this has low modulus, as glass fibers, or low transversal strength, such as carbon fibers. Moreover, the longitudinal stress concentration can damage the reinforcing material only if this has high stiffness, as in the cas…

Anisotropic scaling of tectonic stylolites: A fossilized signature of the stress field?

2010

International audience; [1] Vertical stylolites are pressure solution features, which are considered to be caused by horizontal tectonic loading, with the largest principal compressive stress being (sub-) parallel to the Earth's surface. In the present study we analyze the roughness of such tectonic stylolites from two tectonic settings in southern Germany and northeastern Spain, aiming to investigate their scaling properties with respect to the stress during formation. High-resolution laser profilometry was carried out on opened stylolite surfaces of nine samples. These data sets were then analyzed using one-and two-dimensional Fourier power spectral approaches. We found that tectonic styl…

Crustal dynamics of Mount Vesuvius from 1998 to 2005: Effects on seismicity and fluid circulation

2008

[1] This paper presents the results of hydrogeochemical and seismological studies carried out at Mount Vesuvius during the period June 1998 to December 2005. Hydrogeochemical data show the occurrence of slowly varying long-term variations in the total dissolved salts and bicarbonate contents of the groundwaters, accompanied by a general decline in water temperatures. The temporal distributions of air temperature and rainfall in the Vesuvius area suggest that these variations do not depend on changes in the hydrological regime. The changes in the geochemical parameters are accompanied by slight variations in both the seismicity rate and energy release. A further relationship between seismic …

The influence of platform switching on the biomechanical aspects of the implant-abutment system. A three dimensional finite element study

2011

Objective: To evaluate the biomechanical scenario of platform switching geometric implant-abutment configuration relative to standard configurations by means of finite element analysis.Study Design: A 3D Finite Element Analysis (FEA) was performed on 3 different implant-abutment configurations: a 3.8 mm implant with a matching diameter abutment (Standard Control Design, SCD), a 5.5 mm implant with matching diameter abutment (Wider Control Design, WCD), and a 5.5mm implant with a 3.8 mm abutment (Experimental Design, ED). All the different experimental groups were discretized to over 60000 elements and 100000 nodes, and 130N vertical (axial) and 90N horizontal loads were applied on the coron…

Shear capacity in concrete beams reinforced by stirrups with two different inclinations

2014

Abstract A model for the estimation of shear capacity in Reinforced Concrete (RC) beams with web reinforcement is provided by introducing a generalization of classical plastic Nielsen’s model, which is based on the variable-inclination stress-field approach. The proposed model is able to predict the shear capacity in RC beams reinforced by means of stirrups having two different inclinations and longitudinal web bars. A numerical comparison with the results of experimental tests and those provided by a Finite Element Model (FEM) based on the well known theory of Modified Compression Field Theory (MCFT) is carried out for validating the robustness of the proposed model. Finally, a set of para…

Precursor effects of the Rhombohedral-to-Cubic Phase Transition in Indium Selenide

2002

We report on the observation of precursor effects of the rhombohedral-to-cubic phase transition in Indium Selenide (InSe) with several experimental techniques. The pressure at which these precursor defects are first observed depends on the sensitivity of the experimental technique. In transport measurements, which are very sensitive to low defect concentrations, precursor effects are observed 5 to 6 GPa below the phase transition pressure whereas in X-ray diffraction measurements precursor effects are only observed 2 GPa below the phase transition pressure. We report optical absorption measurements, in which the precursor effects are shown by the growth and propagation of dark linear defect…

Reliable measures of plastic deformations for elastic plastic structures in shakedown conditions

2020

A new formulation for evaluating reliable measures of the plastic deformations occurring in the transient phase of a structure in shakedown conditions is proposed. The structure is thought as constituted by elastic perfectly plastic material and subjected to a combination of fixed and cyclic loads. The proposed formulation consists in the search for the optimal plastic strain field that minimize a suitable objective function defining a strain energy measure related to the plastic strains at the shakedown limit. The typical self-stress field can be obtained as the elastic structural response to an assigned plastic strain field respecting appropriate ductility limits for the material. Without…